Improved Yamaha DT200 YPVS CDI unit ignition (37F-M1)
3 Year warranty
Full power version
For:
Yamaha DT200 YPVS (1984-1986) CDI-box igniter brain
OEM numbers:
37F-M1
37F-M1 40223
37F-85540-M1-00
Other names:
EC Ignitor, brain, ignition module, Spark unit
CDI, TCI, ECU, ECM computer, Black Box, Ignitor
ignition control module, spark box
Ignition Spark Control Module
CDI Ignition, ignitor unit
Kit contents:
- Carmo TCI unit with wiring harness and connectors
- Ignition coil with HT lead and spark plug cap
- Brown 12V wire (switched ignition) with AMP connector
- Red supply wire with ring terminal (battery +) and faston (coil +)
- Mounting parts (1 kΩ resistor, wire splice connector)
Installation:
Solder the supplied 1 kΩ resistor into the YPVS module, otherwise the power valve will not work.
The brown wire is tapped with the supplied splice connector.
-- INSTALLATION MANUAL (PDF) --
Your bike will perform better with this advanced ignition unit from Carmo electronics!
What's improved compared to the original unit:
- The unit is protected against overvoltage (defective voltage regulator/rectifier, bad battery, jump starter).
- The unit is protected against a defective ignition coil and reverse battery connection.
- The unit has an acceleration correction: when the bike revs up, the advance increases in proportion. Smoother acceleration.
- The unit uses digital technology, so it is more accurate and unaffected by temperature; the curve is also optimised for more power.
- When the battery voltage changes, the unit adapts the coil control so the spark power stays the same.
- Start mode: during engine start the unit gives more current to the ignition coil for a faster start.
- Carmo electronics can also supply a fully programmable version, so you can set the advance, rev limiter and spark energy yourself.
Team-Carmo